国产毛片农村妇女系列bd版

行業新聞

當前位置:網站首頁 > 新聞中心 > 行業新聞

  • 電熔焊機焊接器操作步驟
  • 本站編輯:杭州先創熱熔設備廠發布日期:2020-01-02 20:40 瀏覽次數:
焊接器操作步驟 
 
1.準備工作結束后,打開操作開關,仔細調整工作電流開始焊接。
 
2.因任何原因,電熱熔焊機中途停止工作時,計時器都會記下電流通過的時間。按下rst鍵復 位,重新操作)
 
3.做好準備工作,連接導線—打開電源開關—設定電壓檔和時間—打開操作開關—計時器開始計時—調整電流到設定值(緩調)開始焊接—達到設定時間,蜂音器響自動斷電—關閉操作開關至OFF、電流旋鈕回零—摘下連接線夾子—按規定時間冷卻—檢查—工作結束。
 
4.焊接器會在電壓過高或電流過大的情況下自動斷電,因此,在判斷焊接器是否在正常的數據下工作時,只需關上然后再打開電源,切斷裝置使系統恢復到正常狀態。 
Welding procedure
 
1. After the preparation, turn on the operation switch, carefully adjust the working current and start welding.
 
2. For any reason, when the electric fusion welding machine stops working in the middle of the process, the timer will record the current passing time. Press RST key to reset and operate again)
 
3. Make preparations, connect the wires - turn on the power switch - set the voltage level and time - turn on the operation switch - start the timer - adjust the current to the set value (slow adjustment) and start the welding - when the set time is reached, the buzzer will ring and automatically cut off - turn off the operation switch to off, the current knob returns to zero - remove the connecting clamp - cool down according to the specified time - check - the end of the work.
 
4. The welder will automatically cut off the power when the voltage is too high or the current is too high. Therefore, when judging whether the welder works under normal data, just turn off and then on the power supply, and cut off the device to restore the system to normal state。